操作說明 Operating Instructions - German pool HTS-200 Operating Instructions Manual

操作說明
安裝程序
1.將主機平放桌面，扭開組裝旋鈕(圖1)。
2.將玻璃底座套進主機支撐柱，重新扭緊旋
鈕(圖2)。
3.豎起本機，放在平穩的地面上(圖3)。
主機
Main Body
Fig 1
圖1
操作程序
1.總電源開關
- 檢查插座電壓符合產品使用電壓後，插
上電源。
- 開啟機身背面的總電源開關，發出「嗶
嗶」聲響即表示已進入待機狀態。
2.開關
- 在待機狀態下，除 鍵外，其他按鍵暫
時無效，按 鍵開機，再按一次關機。
3.強弱
- 開機狀態下，按 鍵切換熱力強弱。
1,200W
- 指示燈顯示
Operating Instructions
組裝旋鈕
Securing Nut
2,000W
指低熱， 指高熱。
Assembly of Device
1. Place the Main Body horizontally on a table. Unscrew
the Securing Nut (Fig 1).
2. Insert the Glass Base into the Heater Support Stand.
Use the Securing Nut to screw it tightly (Fig 2).
3. Place the device upright on an even and stable floor
(Fig 3).
主機 玻璃底座
Main Body Glass Base
Fig 2
圖2
Operating Procedures
1. Main Power Switch
- Connect the appliance to the power supply. Make
sure the power voltage and frequency accords with
the requirement of the heater.
- Press the Main Power Switch at the back of the fan
heater. A sound will be heard, which means the
device is in Standby status.
2. On/Off
- Under the condition of Standby, only
to be pressed. Press
press again to turn off.
3. Heating Power
- Press to adjust the heating power.
- On the display, 1,200W indicates low heat. 2,000W
means high heat.
P.7
組裝旋鈕
Securing Nut
圖3
once to turn on the device,
Fig 3
is available