Maintenance - Cub Cadet Pro Z SurePath Auto Steer Series Operator's Manual

• Clean the top of the mower deck, under the spindle covers and belt area. See
Figure 31.
• Clean around and near the transmission, axle and the fan area. See Figure 32.
Wheel Not Shown For Clarity
Storing the Mower
• Allow the machine to cool in an open area before storing.
• Do not park the mower near any flammable materials (wood, cloth or
chemicals) or any open flames or other potential source of ignition (furnace,
water heater or any other type of heater).
• Remove all combustible materials from the mower before storing. Empty cargo
boxes, grass catchers or containers.
• Always shut off fuel flow when storing or transporting if mower is equipped
with a fuel shutoff.
• Check the fuel system (lines, tank, cap and fittings) frequently for cracks or
leaks. Repair and clean as necessary.
Calibration
The SurePath Auto Steer system will need to be calibrated in the
following circumstances:
• Major front end maintenance or replacement occurs.
• GPM or complete steering column is replaced.
Please contact an authorized service dealer for more information regarding
system calibration.

MAINTENANCE

Engine
Refer to the Engine Operator's Manual for all engine maintenance intervals,
procedures, specifications and instructions.
PRODUCT CARE
Figure 31
Figure 32
CHANGING THE ENGINE OIL
If the engine has been recently run, the engine, muffler, and surrounding
metal surfaces will be hot and can cause burns to the skin. Exercise caution
to avoid burns.
Maintain oil level as instructed in Engine Operator's Manual. Be careful not to spill oil
on any of the belts.
To complete an oil change, proceed as follows:
1. Run the engine for a short time to warm the engine oil. The oil will flow more
freely and carry away more impurities. Use care to avoid burns from hot oil.
2. Locate the oil drain hose on the engine. See Figure 33.
3. Remove the hose from the clip securing it to the frame.
4. Route the free end of the oil drain hose toward an appropriate oil collection
container with at least a 2.5 quart capacity, to collect the used oil.
NOTE: Avoid getting oil on the muffler when draining.
5. While holding the free end of the oil drain hose over the oil collection container,
unscrew the square-head hose plug from the end of the hose. See Figure 33.
Drain the engine oil into the collection container.
6. Remove the oil filter to make sure all the oil is drained.
7. After draining the oil, wipe any residual oil from the oil drain hose. Thread the
square head plug into the drain hose fitting and fully tighten the plug.
8. Replace the oil filter and refill the engine with new oil as instructed in
the Engine Operator's Manual. Refer to the Engine Operator's Manual for
information regarding the volume and weight of engine oil.
9. Place the hose back into the clip securing it to the frame.
Lubrication
Periodically lubricate all pivot points with a quality lubricating oil.
Tires
Check the tire air pressure after every 50 hours of operation or weekly. Keep the
tires inflated to the recommended pressures. Improper inflation will shorten the
tire service life and produce an uneven cut. See the tire side wall for proper inflation
pressures. Observe the following guidelines:
• Do not inflate a tire above the maximum pressure shown on the sidewall of
the tire.
• Do not reinflate a tire that has been run flat or seriously under-inflated. Have it
inspected and serviced by a qualified tire mechanic.
27
WARNING
Figure 33