Cub Cadet Pro Z SurePath Auto Steer Series Operator's Manual page 38

Problem
SurePath Auto Steer System
NOTE: SurePath Auto Steer system issues
may be resolved by turning the mower off,
waiting 10 seconds and then turning the
mower back on.
PRODUCT CARE
Cause
1. Indicator/Warning Lights do not flash blue after key is
turned on.
2. Indicator/Warning Lights do not go solid green.
3. Mower is in an open area but Indicator/Warning Lights
stay flashing green with periodic red.
4. Mower is in an open area but Indicator/Warning Lights
stay flashing green (no periodic red).
5. Indicator/Warning Lights flash yellow when you press
a button.
6. Indicator/Warning Lights flash yellow while in Auto
Steer Mode.
7. GPS indicator is ON but SurePath Auto Steer Mode will
not engage.
8. Indicator/Warning Lights flash red while system is being
used in SurePath Auto Steer Mode.
9. Indicator/Warning Lights flash red.
10. SurePath Auto Steer Mode leaves uncut areas between
mowing passes.
11. SurePath Auto Steer Mode is overlapping too much
between mowing passes.
12. SurePath Auto Steer Mode needs to be disabled.
1. Check fuses. Replace with same rating fuse, if necessary.
2. Move away from trees and buildings. Ensure nothing is
blocking the GPM.
3. Check for strength of cellular signal.
4. Verify SurePath Auto Steer subscription as follows:
• Make sure annual subscription has not expired.
• Check if mower has been moved out of the
state(s) where SurePath Auto Steer subscription
was activated.
• Contact an authorized service dealer if the above
items do not resolve.
5. Review the following:
• SurePath Auto Steer system is not ready. Wait for GPS
indicator to be solid green.
• Mower has not traveled minimum recommended
distance to allow setting of the mowing line. See
Setting the Mowing Line (SurePath Auto Steer Mode).
• Invalid reset of mowing line. See Clearing the
Mowing Line (SurePath Auto Steer Mode).
6. Mower speed too fast. Reduce speed.
7. Resume use in manual mode and contact an authorized
service dealer to review active faults.
8. Verify the following:
• If mower is under a tree or near a structure move to
an open area and verify nothing is blocking the GPM.
• Check for strength of cellular signal.
• Resume use in manual mode and contact an
authorized service dealer to review active faults.
9. Resume use in manual mode and contact an authorized
service dealer to review active faults.
10. Turn Cutting Width knob counter-clockwise to increase
mowing overlap.
11. Turn Cutting Width knob clockwise to reduce
mowing overlap.
12. To disable the SurePath Auto Steer Mode:
• Remove GPM fuse (labeled F5:GPM in the fuse box
located under the operator's seat) to disable SurePath
Auto Steer system.
• Contact an authorized service dealer.
38
Remedy