Battery Information; Battery Maintenance - Cub Cadet Pro Z SurePath Auto Steer Series Operator's Manual

Battery Information

Should battery acid accidentally splatter into the eyes or onto the skin,
rinse the affected area immediately with clean cold water. Seek prompt
medical attention.
If acid spills on clothing, first dilute it with clean water, then neutralize with
a solution of ammonia/water or baking soda/water.
NEVER connect (or disconnect) battery charger clips to the battery while the
charger is turned on, as it can cause sparks.
Keep all sources of ignition (cigarettes, matches, lighters) away from the
battery. The gas generated during charging can be combustible.
As a further precaution, only charge the battery in a well ventilated area.
Always shield eyes and protect skin and clothing when working
near batteries.
Batteries contain sulfuric acid and may emit explosive gases. Use extreme
caution when handling batteries. Keep batteries out of the reach
of children.
The battery may present a risk of fire or chemical burn if misused. Do not
open, disassemble, overheat, or incinerate the battery.

BATTERY MAINTENANCE

• The battery is filled with battery acid and then sealed at the factory. However,
even a "maintenance free" battery requires some maintenance to ensure its
proper life cycle.
• Spray the terminals and exposed wire with a battery terminal sealer, or
coat the terminals with a thin coat of grease or petroleum jelly, to protect
against corrosion.
• Always keep the battery cables and terminals clean and free of corrosion.
• Some models are equipped with a battery containing a liquid electrolyte.
Handle the battery with care and avoid tipping to prevent leakage.
Batteries contain sulfuric acid and may emit explosive gases. Use extreme
caution when handling batteries. Keep batteries out of the reach
of children.
BATTERY STORAGE
1. When storing the mower for extended periods, disconnect the negative battery
cable. It is not necessary to remove the battery.
2. All batteries discharge during storage. Keep the exterior of the battery clean,
especially the top. A dirty battery will discharge more rapidly.
3. The battery must be stored with a full charge. A discharged battery can freeze
sooner than a charged battery. A fully charged battery will store longer in cold
temperatures than hot.
4. Recharge the battery before returning to service. Although the mower may
start, the engine charging system may not fully recharge the battery.
PRODUCT CARE
WARNING
WARNING
REMOVING THE BATTERY
Battery posts, terminals, and related accessories contain lead and lead
compounds. Wash hands after handling.
1. Flip the seat all the way forward.
2. Remove the hex screw securing the black negative battery lead (a) to the
negative battery post (marked NEG). Move the cable away from the negative
battery post. See Figure 34.
3. Remove the hex screw securing the red positive battery lead (b) to the positive
battery post (marked POS). Move the cable away from the positive battery
post. See Figure 34.
a
4. Locate and hold the carriage bolt (a) at the front of the battery bracket (c) to
prevent it from falling. See Figure 35.
5. Remove the hex lock nut (b) securing the battery bracket (c) in place. Save the
carriage bolt and hex lock nut for later reinstallation. See Figure 35.
6. Lift the battery bracket (c) off of the tab at the left side of the battery
compartment and save for later reinstallation. See Figure 35.
c
Using the Transmission Bypass Levers
If for any reason the mower will not drive or you wish to move the mower, the two
hydrostatic transmissions are equipped with a bypass rod that will allow you to
manually move the mower short distances.
Do not tow the mower, even with the bypass rod engaged. Serious
transmission damage will result from doing so.
28
WARNING
b
Figure 34
b
a
Figure 35
WARNING