Operation - Cub Cadet Pro Z SurePath Auto Steer Series Operator's Manual

T
†
S
U
†
G
†
H
B
AB
†
K
AC
NOTE: This Operator's Manual covers several models. Mower features may vary by
model. Not all features in this manual are applicable to all mower models and the
mower depicted may differ from yours.
NOTE: All references in this manual to the left or right side and front or back of the
machine are from the operating position only. Exceptions, if any, will be specified.
A. IGNITION
The ignition switch is located on the RH console to the rear of
the throttle control. The ignition switch has three positions
as follows:
STOP — The engine and electrical system are turned off.
STOP
RUN — The mower electrical system is energized.
START — The starter motor will turn over the engine. Release the key
immediately when the engine starts.
NOTE: To prevent accidental starting and/or battery discharge, remove the key from
the ignition switch when the mower is not in use.

OPERATION

OPERATION
AD I
W
Y
AC
Figure 20
AE
J
Z
AA
X
AB
†
K
B. TRANSMISSION BYPASS LEVER
Do not tow the mower, even with the bypass valves engaged.
Serious transmission damage will result from doing so.
The transmission bypass lever is located next to the LH console to the left
of the operator's seat.
When engaged the valves open a bypass within the hydrostatic
transmissions. Refer to the Set-Up section for instructions on using the
bypass feature.
13
AB
†
E
†
†
WARNING
A
D
C
F