Steering Wheel; Operator's Seat - Cub Cadet Pro Z SurePath Auto Steer Series Operator's Manual

Steering Wheel

IMPORTANT! Do not use impact tools to install or remove the steering wheel. Doing
so may cause damage to critical power steering components.
1. Remove the hardware for attaching the steering wheel from beneath the
steering wheel cap (a). Carefully pry off the steering wheel cap (a) to remove
the hardware. See Figure 6.
2. With the wheels of the machine pointing straight forward, place the steering
wheel (b) over the steering shaft. See Figure 6.
3. Place the Belleville washer (c) over the steering wheel (b) and secure with the
hex lock screw (d). See Figure 6.
4. Place the steering wheel cover over the center of the steering wheel and push
downward until it "clicks" into place.

OPERATOR'S SEAT

1. Remove the two flange lock nuts (b) and shoulder bolts (a) from the manual
bag. See Figure 7.
a
2. Place the seat into position and secure the seat into place with the hardware as
shown in Figure 7.
3. Remove the shoulder screw (a) and flange lock nut (b) from manual bag and
install the seat lockout bracket (c) as shown in Figure 8.
b
c
Figure 6
a
b
b
Figure 7
b
a
c
Figure 8
SET-UP
4. Insert the wiring harness (a) into the bottom of the seat as shown in Figure 9.
NOTE: When the wiring harness (a) is connected, be sure to push the excess
wire from the wire harness (a) into the seat box hole before continuing. See
d
Figure 9.
5. Remove the screw (a) securing the recliner plate in the seat back position. See
Figure 10.
a
6. Tilt the seat forward into the full forward position. Replace the recliner plate
with the clinch-stud (a) and the recliner pin (b) passing through the recliner
plate in the locations shown in Figure 11.
10
a
a
Figure 9
a
Figure 10
a
b
Figure 11