Table of Contents
Advertisement
MT56DSU2 Owner's Manual
2.4 Installation Procedure
Installation of the MultiDSU56K includes making cable connections to the back panel and turning power
on. The MultiDSU56K back panel is shown below.
Perform the steps below to install the MultiDSU56K.
Perform the following procedure to install your MultiDSU56K.
1.
Verify that the Dip switches on the MultiDSU56K are set for your particular configurations; refer
to Table 2-1.
2.
Connect the appropriate MultiDSU56K back panel DTE interface connector, depending on the
DTE:
• Connect the RS232C connector to the 25-pin DB25S receptacle. Use the two screws to secure
the connection, or
• Connect the 34-position rectangular V.35 connector to the V.35 receptacle.
3.
Connect the "LINE" Jack of the MuIt1DSU56K to the DDS receptacle using the line cord
provided with the MultiDSU56K.
Note:
any cables connected to the computer should be shielded to reduce interference.
4.
Connect the other end of the interface cable to the DTEs port connector.
5.
Plug in the MultiDSU56K Power Cord into the POWER jack on the MultiDSU56K back panel.
6.
Plug the power transformer into an appropriate electrical outlet.
7.
Turn the MultiDSU56K POWER switch On. The MultiDSU56K will now operate as described in
Chapter 3 of this manual.
82017502
Figure 2-2. MultiDSU56K Back Panel
Table 2-2. Hardware Installation Procedure
14
Advertisement
Table of Contents
