Mcsi Setup For Connection To A Serial-To-Ethernet Device; Set Up The Multiconnect Serial-To-Ethernet Device (Mts2Ea); Set Up The Mcsi Software - Multitech MTS2EA Reference Manual

MCSI Setup for Connection to a Serial-to-
Ethernet Device
A. Set Up the MultiConnect Serial-to-Ethernet Device (MTS2EA):
Connect and login to the serial port, or use telnet and go to the Ethernet port.
1.
If you use telnet, you must have a DHCP and you must know the IP address of the
Note:
Serial-to-Ethernet device (MTS2EA).
Login using the default login (admin) and the default password (admin).
2.
Once you are logged into the MTS2EA, you can enter the list of commands below.
3.
If you get an OK response, the command was entered correctly. If you get any other
Note:
response, you will have to enter the command again.
# set ag-server enable
# set ip eth0 dhcp-client disable
# set ip eht0 ip-address 192.168.2.1
# set ip auto-dialout enable
# set ip telnet raw-mode enable
# set serial s0 auto-dialout enable
# set serial s0 raw-dialout enable
# set serial s0 auto-dialout-port 5000
# set serial s0 auto-dialout-protocol telnet
# set serial s0 baud-rate 115200
# set serial s0 data-bits 8
# set serial s0 parity none
# set serial s0 stop-bits 1
# set serial s0 flow-control rts-cts
# save
Note: All values are the default values and can be changed to customize your setup, if
needed.
B. Set Up the MCSI Software:
Important Setup Note:
trying to connect.
Preliminary Step:
Install the MCSI software. The software is available on the CD provided with the product you purchased,
or it can be downloaded from the Multi-Tech Web site or FTP site:
ftp://ftp.multitech.com/mts-software/rasexpress/
File name for current release: MCSI_2K-XP_105.ZIP
http://www.multitech.com/SUPPORT/Families/CommPlete4000/software.asp
File name for current release: MCSI_2K-XP_105.ZIP
Multi-Tech Systems, Inc. MCSI and Serial-to-Ethernet Device Setup Example – A Reference Guide

MCSI Setup for Connection to a Serial-to-Ethernet Device

The serial side of the IP module cannot be in command mode when MCSI is
3