JPT YDFLP-E-60-M7-M-R User Manual page 22

User can select this mode to lock a specific frequency or output power individually when don't
want to control it by external signal.
Set parameters and emitting
2
Figure 18 Setting parameters and emitting
After selecting full control mode, user can set power, frequency, pulse width and then press
"edit" button to confirm. User can switch on/off emission when clicking "Laser" button.
Note: All the parameters except power can't be modified during emission.
Control MO signal
3
Ctrl MO: The "MO" button will be appeared on the interface after selecting Ctrl MO. User can
control the switching of MO signal while clicking this button. This setting will not be preserved
after power off.
Figure 19 GUI control MO state
18
YDFLP-E-60-M7-M-R User Manual
File Number: S-PI-0035