General Description - Zephir ZBH20CM Manual

GENERAL DESCRIPTION

A. Air inlet
B. Air outlet
C. Selector switch
D. Thermostat
HOW TO USE
Note:After switching on the heater for the first time and after some time without using a short-term odour will be possible
Place the heater on a flat level and stable surface.
The unit can stand in a horizontal position and also can mount the heater on a flat stable surfaces.
Put the selector switch to position ( ) OFF. Plug the power socket in the wall-socket.
The selector switch (C), enable you to select the following functions:
Selector switch(C):
= "OFF". Both the fan and the two heating elements are switched off.
= "Cool air". Only the fan is switched on.
=I "Warm air" (1000 W) for gradual heating-up.
=II "Hot air" (2000 W) for quick heating-up.
Thermostat knob(C):
With the thermostat knob you can set a constant room temperature.
When the selector switch is set to position l or position ll the heater will automatically switch on as soon as the room
temperature falls below the set temperature . As soon as the set temperature is reached . they will switch off . Rotate
the knob clockwise to obtain a higher thermostat during ues .To find the ideal thermostat setting
First set the knob to maximum position (rotate clockwise until the knob stops)
-
As soon as the temperatue is comfortable . turn the knob anti-clockwise slowly until the heater goes off.
-
When using the cool air setting
Switch off the heater:
To switch off the heater turn the selector switch to the position ( ). Remove the mains plug from the wall-socket.
Always unplug the heater from the wall-socket when not in use.
Revolving:
The heater can 90 degree revolving. See figure.
OVERHEATING SAFETY DEVICE
To prevent damage and risks due to overheating, the built-in overheating safety device cuts off the power as soon as the
heating elements become too hot. If this should happen:
the thermostat knob should be in its highest posltion.
D