Chart Recorders (Optional)
8 Chart Recorders
(Optional)
8.1 Set Up and
Operation
12
Installation and Operation Manual
Panel-mounted six-inch seven-day recorders are available as optional accessories.
To prepare the recorder to function properly, complete the following steps:
1. Open the recorder door to access the recorder.
2. Connect the nine volt DC battery located at the recorder's upper right
corner. This battery provides backup power.
3. Install clean chart paper (refer to Section 8.3).
4. Remove the plastic cap from the pen stylus and close the recorder door.
Recorder operation begins when the system is powered on. The recorder may
not respond until the system reaches temperature within the recorder's range.
Chart Buttons
Imprinting
Stylus
Reference
Mark
IMPORTANT: Do not use sharp or pointed objects to depress the
chart buttons. This may cause permanent damage to the recorder.
9 Volt Battery
Hub-Nut and
Retaining Wire
Figure 3. Chart Recorder
Figure 4. Chart Buttons
Thermo Scientific Benchtop Ultra-Low Temperature Freezers
Chart