Installation; Installing The System - Marport M6 PRO User Manual

Hide thumbs Also See for M6 PRO:

Table of Contents

Read this section to learn how to connect and configure the equipment of the M6

system.

Marport technicians or dealers need to connect the different components of the

system.

Note: The system is installed by Marport or by a dealer. If there is a problem,

you can read these installation steps to check the system installation.

1. Check that you have all the items needed for the installation (See Equipment List

(on page 11))

2. Install the hydrophones and their cables, or find the cables from hydrophones

that have already been installed.

3. Route the hydrophone cables toward the junction boxes.

4. Put the receivers elevated and/or fixed vertically on a wall in a dry and

clean area, as close as possible to the hydrophones. If the receivers are in a

closed environment, make sure it is enough ventilated and that the ambient

temperature does not exceed 55 °C (131 °F).

Note: Make sure that the cables from the junction boxes are long enough

to reach the receivers.

5. Install the Mac computer and Mx computer elevated and/or fixed vertically on a

wall, in a dry and ventilated area, without dust, in the wheelhouse.

CAUTION: The receivers are water resistant but not waterproof. The

computers are not water resistant. In order to prevent the equipment

from being damaged by water:

◦ Do not install the receiver and computer directly on the floor.

◦ The cable connectors must not point upwards.

6. Install the monitor(s).

Installation

M6 PRO | V6 | Installation

Table of Contents