Networks & Services; Networks & Services > Networks - Multitech RouteFinder RF850 User Manual

Networks & Services
Networks & Services > Networks
A network always consists of a Name, an IP address, and a Subnet Mask address. Once you add a network, the
information displays at the bottom of the screen.
Important Notes:
•
The first four networks on this screen are default entries and cannot be changed.
•
LAN and WAN interfaces will change if changes are made to LAN/WAN IP addresses in Network Setup.
•
To define a single host, enter its IP address and use a netmask of 255.255.255.255. Technically, single
hosts are treated in the same way as networks.
•
You can also use the bit "spelling" for the Subnet mask (e.g., write 30 instead of 255.255.255.252).
•
A network or host can be deleted only if it is not used for any route or by any other module.
•
If a network is being used by a routing section, that network cannot be edited. Similarly, if a host
address is edited and changed to a network address, and if that host was used by SNAT or DNAT, the
changed will not be performed.
Networks/Hosts Listed When Load Balancing Is Disabled
Networks/Hosts Listed When Load Balancing Is Enabled
Add Network
Name
Enter a name into the Name entry field. This name is later used to set packet filter rules, etc.
Accepted characters: alphabetic, numerical 0 to 9, the minus sign, underscore. Maximum
characters are 39.
IP Address
Enter the IP address of the network.
Subnet Mask
Enter the Net Mask.
How to Confirm Your Entries
Confirm your entries by clicking the Add button. After clicking the Add button, the Networks you
have setup display on the lower part of the screen. Example:
Name
RemoteLAN
RemoteWAN_IP 204.26.122.3
Multi-Tech Systems, Inc. RouteFinder RF850/860 User Guide (PN S000400E)
IP Address Subnet Mask Options
192.168.100 255.255.255.0
255.255.255.255
Chapter 6 – RouteFinder Software
Networks & Services > Networks
Edit | Delete
Edit | Delete
60