Vpn Setup - Multitech RouteFinder RF850 User Manual

Packet Filters > Packet Filter Rules
1. Go to the Packet Filters > Packet Filter Rules screen to set the VPN client tunnel rights. The
Packet Filter rights established on this screen give the client access across the tunnel to your
host network.
2. In the System Defined Rules section, uncheck the Status box, if a check mark is present when
setting up User Defined Rules.
3. In the Add User Defined Packet Filter Rules section, click on From (Host/Networks) and select
the network to be allowed.
4. In this example, select Remote-WAN.
5. If you are not restricting the type of Service, select Any.
6. If you are not restricting any Network. Click on To (Host/Network), select Any.
Notes:
•
If the client is dynamic (unknown), set up a Remote-WAN Any Any ACCEPT filter to allow any
network to come in.
•
You might want to add LAN Any Any ACCEPT to the User Defined Packet Filter Rules. If you
want this rule to be in the first position so that it takes precedence over the VPN-Client rule,
select the Move command, and move this rule to the first position.

VPN Setup

1. Go to the VPN > IPSec screen.
2. Click the VPN Status check box to enable IPSec. Then click the Save button.
3. Select Add IKE Connection by clicking the corresponding Add button.
Multi-Tech Systems, Inc. RouteFinder RF850/860 User Guide (PN S000400E)
Chapter 4 – Configuration Examples
Example 1, Side A
25