Control Box - External Installation - Mitsubishi Electric PAAA18AA1 Installation Manual

Secure the control box with the M5 screws provided in the accessories bag by drilling four 3/16" pilot holes
in the locations indicated below. Exact location and dimensions to install the control box on the cabinet is
displayed below:
NOTE
• Match drill holes (4) per layout.
• Only drill through the sheetmetal. Drilling any further can damage the coil.

14.2. Control box - external installation

NOTE
Mounting the control box on a secured wall close to the cabinet is an acceptable mounting
method.
If the control box is to be installed on an alternative location, it is the responsibility of the installer to secure
the control box properly and ensure all wiring between the control box and cabinet reaches and is secure.
Specifications are subject to change without notice.
PAA-A18, 24, 30, 36, 42AA1/BA1/CA1
73
Pilot hole locations
© 2022 Mitsubishi Electric US, Inc.