Remote Control; Controls - Emotiva UMC-1 Operation Manual

6| REMOTE CONTROL

8. RETURN
The RETURN button takes you back to the previous OSD screen and if pressed repeatedly will exit the menu.
9. MENU
The MENU button will initiate the OSD menu.
•

CONTROLS

ON
1.
The ON button powers the UMC-1 on from standby mode. When the ON button
is pressed the amber light of the power button will turn blue and LOADING will
appear in the display window for approximately 3 seconds. EMOTIVA will appear
in the display window for approximately 3 seconds. The last selected input will
appear and the volume will ramp up to its previous setting. (As an alternative,
you can turn on the UMC-1 via the Standby button on the front panel.)
MUTE
2.
The MUTE button mutes the sound. Press it down once to mute the sound, press
it down again and the sound returns to its previous volume. When muted, a
window will display on the OSD that says "Mute". Please note that the mute
button not only mutes audio output from the UMC-1 itself, but also the audio
from the HDMI stream.
OFF
3.
The OFF button returns the unit to Standby mode. (Note: If the volume is set
high when the unit is place in Standby mode, the volume will return to its
previous high setting when turned back on.) When you press the OFF button, the
display on the UMC-1 itself will show "Power Off." It will display this for
approximately 5 seconds, then the VFD will shut off and the Standby button will
begin to blink violet for a few seconds. During this time, the UMC-1 is saving all
of your settings to memory before it powers down.
INPUT
4.
The INPUT buttons toggle between the inputs of your UMC-1. (Note: This is
where setting up the UMC-1's inputs becomes important. If you have only two
source devices connected to your UMC-1 in the INPUT setup menu under VISIBLE
you can set it to NO for all the unused inputs. Thus, allowing you to scroll
through the only two source units you have connected instead of scrolling
through all 16 possible inputs).
DIM
5.
The DIM button dims the display lights on your UMC-1. It has 10 settings that
allow you to adjust the brightness to your liking or turn the display lights off
completely.
INFO
6.
The INFO button shows what is actually being sent into the UMC-1 by your
source unit. When pressed, the INFO button displays all the information of the
current source unit and what is playing. An example of this would be input type
and format.
7. VOL
The VOL buttons raise and lower the volume of the UMC-1.
25