Umc-1 Front Panel Layout - Emotiva UMC-1 Operation Manual

5| UMC-1 FRONT PANEL LAYOUT

1. Navigation Buttons
These buttons allow you to navigate through the menu systems and change inputs on the fly. The enter button in
the middle functions the same way as the enter button on the remote control.
2. Return Button
This button returns you to the previous menu level. It will exit out of the menu entirely if pressed repeatedly.
3. Power Button
This turns the UMC-1 on or off. It is a non-latching momentary button. When the power button (it is glowing amber
when in standby mode) is pressed, LOADING will appear in the display window for approximately 3 seconds.
EMOTIVA will appear next in the display window for approximately 3 seconds. The unit will then return to the
previously set input and volume levels before it was powered off. The UMC-1 is now ready to use.
*This can also be completed by pressing the ON button on the remote control. When the primary Zone or
Zone-2 is active, the power button is BLUE.
4. Menu Button
This button accesses the UMC-1's Setup, Control, and Function menus. These menus can be seen on the unit itself
as well as the OSD on the TV.
5. Display Window with integrated IR Receiver
This multi-purpose window will display all necessary information such as incoming stream, outgoing format,
volume, menus, etc. The IR Receiver is located in the far right side of the display window. This window should be
clean and free from obstruction for the remote control to work.
6. Volume Knob
This controls the volume of the unit. The display will show "00" at the lowest volume level and "80" at the highest
volume level.
21