Umc-1 Rear Panel Layout - Emotiva UMC-1 Operation Manual

6| UMC-1 REAR PANEL LAYOUT

FM Antenna
1.
The supplied FM antenna fits this "F-Type" screw on connector. Other antennas can be fitted for improved
reception. Be sure to follow proper grounding techniques when using an external antenna. (see page 6)
AM Antenna
2.
These connections are for the included AM loop antenna.
7.1 Channel Analog Inputs (highlighted in yellow)
3.
These analog audio inputs connect to the outputs of an external mulit-channel source unit such as DVD-Audio,
SACD or a DVD player with its own surround decoder. You can assign this as an audio input from the front panel or
remote control in the input setup menu. The seven channels of analog audio will then pass through the UMC-1 as a
pure analog path.
Note: This is designed to be a very short, ultra pure, analog-only signal path. DSP-based effects such as tone controls,
bass management and DSP surround are bypassed in order to maintain the highest fidelity. This input is not available in
Zone 2. The only tonal adjustment for this is LFE level.
7.1 Channel Analog Output (highlighted in blue)
4.
These line-level RCA outputs connect to the inputs of your amplifiers and powered subwoofer(s). There are
outputs for Front Left, Front Right, Left Surround, Right Surround, Center Channel, Subwoofer, Left Back Surround
and Right Front Surround. These are high quality buffered outputs with a maximum output level of 7vRMS.
XLR Subwoofer Output
5.
This line-level balanced XLR output connects to the XLR input of your powered subwoofer. If your powered
subwoofer has a choice of inputs, we recommend using the XLR balanced type. This gives better noise rejection,
especially for longer cable runs.
Analog Inputs (highlighted in red)
6.
DVD (1), CD(2), Cable(3), Aux(4) – These analog audio inputs connect to the outputs of a source component. When
using these inputs and direct mode, they are a pure analog path through the system. In all other modes, the signal
is routed throughout the DSP (Digital Signal Processor).
Special Purpose Output (highlighted in orange)
7.
Mix - Stereo or 2 channel analog multi channel mix down output for fixed level monitoring (RCA)
Zone - Stereo analog variable and independent Zone 2 output (RCA)
Rec – Stereo analog fixed level record output (RCA)
Mic In
8.
This connects to the supplied microphone for automatic speaker, crossover and speaker distance setup of
the EMO-Q auto calibration. (It is not recommended to use any other microphone, as the calibration files
will not match.)
Larger diagram of back panel on inside back cover.
22