Renault Arcana User Manual page 62

CHILD SAFETY: fitting a child seat, general information
In the rear side seat
A carrycot can be installed across the
vehicle and will take up at least two
seats. Position the child with his or her
feet nearest the door.
Move the front seat as far forward as
possible to install a rear-facing child
seat, then move back the seat in front
as far as it will go, although without al-
lowing it to come into contact with the
child seat.
For the safety of the child in the for-
ward-facing position:
– move the relevant seat backwards
as far as possible;
– move the seat in front of the child
forwards, and set the position of the
seatback to avoid contact between
the seat and the child's legs.
Ensure that the child seat
or the child's feet do not
prevent the front seat from
locking correctly. ➥ 3.32.
1.48
Always remove the headrest from the
rear seat on which the child seat is po-
sitioned. ➥ 3.31. If necessary, posi-
tion the rear seat as far back as pos-
sible. This must be done before fitting
the child seat. Check that the child seat
is resting against the back of the rear
seat.
A child seat with floor sup-
ports must never be in-
stalled on the rear centre
seat.
RISK OF DEATH OR SERIOUS
INJURY.
When fitting a child seat
(Group 2 or 3 booster seat),
check that the seat belts
operate (wind) correctly
➥ 1.28. If necessary, adjust the po-
sition of the vehicle seat.
(2/2)
Fit the child seat in a rear
seat wherever possible.
To install an ISOFIX seat in
this seat, unbuckle the seat
belt by hand before engaging the
bolts.
Fitting a seat ISOFIX in
the rear-left seat means
the middle seat cannot be
used. The central seat belt
will no longer be either accessible or
useable.