Connecting The S88-3 - tams elektronik S88-3 Manual

S88-3 English

7. Connecting the S88-3

The S88-3 has two RJ45 sockets to connect commercial Ethernet patch-
cables (RJ45 cables), which allow an interference free connection to
other feedback modules or digital devices.
Use a 6-conductor connecting cable for the connection of digital devices
or customary feedback modules which you connect to the 6-pole
connector of the S88-3. Alternatively you can use a special adapter
(optional extra) for the connection via a patch-cable.
Follow the connections diagram fig. 3.
First connect the s88 feedback module to the central unit / the
memory / the interface for a functional test. Afterwards connect all
inputs of the feedback module one after the to the module´s earth
connector X2 by inserting the connecting cable into the terminal strips
and screw it down. Check if the correct status message is shown for all
inputs.
After performing a successful functional test install the s88-feedback
module at the desired place on your model railway. Connect the inputs
1 to 16 to the rail contacts and connect the module to the central unit /
the memory unit / the interface unit or to another feedback module.
Page 29