Bevel Rip Cutting - Titan TTB763TAS Manual

TTB763TAS by TITAN
the work piece that will pass between the blade and the fence.
> Do not place your thumbs on the table top. Always hold the work piece while the
blade is turning. Do not let go of it in order to reach for the push stick. When both
thumbs touch the front edge of the table, complete the cut using a push stick.
> Always use the push stick when performing ripping operations.
> Continue to push the work piece with the push stick until it passes the
blade guard and clears the rear of the table.
> Do not pull the work piece backward while the blade is turning. Turn the switch
OFF, and unplug the power cord. Wait until the blade comes to a complete stop
and slide the work piece out.

Bevel rip cutting

Bevel rip cutting is the same as ripping, except that the blade bevel angle is set to
an angle other than "0".
> Adjust the saw blade to the desied bevel angle. Make sure the bevel locking
handle is locked firmly.
> Follow the same instruction of " Rip cutting ".
Warning: Risk of injury!
The work piece and the fence must be on the right side of
the blade when cutting.
Fig. 15
Product functions
EN
43