Sample Menu - TSI Instruments AeroTrak 9303 Operation Manual

S a m p l e M e n u
The Sample Menu sets sample mode, cycle mode, sample time, hold time,
cycle count, sample units, and channel 2 size.

SAMPLE MENU

Sample Mode COUNTS
Cycle Mode AUTO
Sample Time 01:00
Hold Time 00:30
Cycle Count 010
Sample Units LITER
Chan 2 Size 0.5µm
<
Sample Menu
The following table describes the options of this menu and the parameters
you can set.
Option Description
Sample Mode Use < and > to set
the sampling mode.
Cycle Mode Use < and > to set
the sampling mode.
Sample Time Press the Enter
key to go to a
secondary screen
where you can set
the sample time.
Hold Time Press the Enter key
to go to a secondary
screen where you
can set the time
between samples.
Press the Enter key
Cycle Count
to go to a secondary
screen where you
can set the number
of samples to take.
Operation
>
Parameters
Concentration (see notice
below); counts
Manual – the counter will start
when the RUN soft key is
pressed and stop only when the
STOP soft key is pressed.
Auto – the counter will start
when the RUN soft key is
pressed and turn on and off
automatically to follow the
sample time, hold time and cycle
count parameters below.
Minutes and seconds up to 99:59
(see note below)
Minutes and seconds up to 99:59
1 to 999
3-7