Evi Layer 2 Multicast Configuration Example - H3C S12500 Series Configuration Manual

Configure all the other sites in the same way that site 1 is configured. Make sure extended VLANs
3.
are correctly configured at each site.
Verifying the configuration
# Display neighbors registered with the ENDS in each EVI network.
[Site4] display evi neighbor-discovery server member
Interface: Tunnel101
IP Address: 172.16.4.1
Client Address
172.16.2.1
172.16.3.1
172.16.4.1
Interface: Tunnel102
IP Address: 172.16.4.1
Client Address
172.16.1.1
172.16.2.1
172.16.3.1
172.16.4.1
172.16.5.1
Interface: Tunnel103
IP Address: 172.16.4.1
Client Address
172.16.1.1
172.16.4.1

EVI Layer 2 multicast configuration example

Configure the EVI network (network ID 1) in
at 228.8.8.8 in VLAN 100. The multicast source is connected to Switch A in Site 1, and a receiver host
is attached to Switch B in Site 2.
In the EVI network, Switch A is the ENDS, and Switch B is the ENDC.
Network ID: 1
System ID Expire
000F-0001-0002 25
000F-0001-0003 15
000F-0001-0004 20
Network ID: 2
System ID Expire
000F-0001-0001 19
000F-0001-0002 25
000F-0001-0003 15
000F-0001-0004 20
000F-0001-0005 18
Network ID: 3
System ID Expire
000F-0001-0001 19
000F-0001-0004 20
Created Time
2011/01/01 00:00:43
2011/01/01 01:00:46
2011/01/01 01:02:13
Created Time
2011/01/01 00:19:31
2011/01/01 00:00:43
2011/01/01 01:00:46
2011/01/01 01:02:13
2011/01/01 01:04:32
Created Time
2011/01/01 00:19:31
2011/01/01 01:02:13
Figure 10 to transmit multicast traffic for the multicast group
28