Cleaning Of The Spray Gun - SATA minijet 4400 B Operating Instructions Manual

Operating instructions SATAminijet 4400 B RP/HVLP
7.2. Adjust material flow
rial flow control fully opened
With the material flow control fully opened, the wear of the fluid tip and
paint needle is reduced to a minimum. Please select the correct nozzle
size depending on the material to be applied and the required applica-
tion speed.
7.3. Adjust spray fan pattern
• Adjust flat fan (factory setting) [5-1].
• Adjust round fan [5-2].
7.4. Painting
Fully pull trigger for painting [6-1]. Operate spray gun according to [6-2].
Maintain spray distance as described in chapter 2.
8.

Cleaning of the Spray Gun

• Prior to cleaning, please disconnect the spray gun from the com-
pressed air circuit!
• Risk of injury due to unexpected leakage of compressed air or mate-
rial!
• Empty spray gun and gravity flow cup completely, dispose of paint
material appropriately!
• Disassemble and install components very carefully! Exclusively use
included special tools!
• Use neutral cleaning solution (pH value 6 to 8)!*
• Do not use acids, lyes, bases, pickling agents, unsuitable
regenerates or other aggressive cleaning solutions!*
• Do not soak paint spray gun in cleaning solution!*
• Do not clean cover plate of the electronic pressure display with
pointed, sharp or rough objects!
EN-Content-BAL-SATAminijet 4400 B.indd 7
[4-1], [4-2], [4-3] und [4-4] - mate-
Note!
Warning! Attention!
EN
7
06.05.2014 10:14:32