Table of Contents
Advertisement
Introduction
The PGRM series of pole mounts are a sturdy, economical universal pole mounting solution with user adjustable
angle settings (0° to 60°).
NOTE: 4-inch Schedule 40 (Sch-40) steel support pipe and 3" Sch-40 Horizontal Beam pipe is user supplied.
Galvanized coated sheet steel used in the MID Clamps and END Clamps will show rust on cut edges. This is
normal and will not affect the structure and function of the mount.
Installer Responsibility
The installer is solely responsible for the following:
Comply with all applicable local or national building codes, including any that may supersede this manual.
Ensure that Tamarack Solar parts and other products are appropriate for the particular installation and the
installation environment.
Use only Tamarack Solar parts and installer-supplied parts as specified by Tamarack Solar. Substitution parts
may void the warranty;
Ensure safe installation of all electrical aspects of the PV array.
Ensure correct and appropriate design parameters are used in determining the design loading used for the
specific installation. Parameters, such as snow loading, wind speed, exposure and topographic factor should be
confirmed with the local building official or a licensed professional engineer.
Customer Support
Tamarack Solar makes every effort to ensure your mounting kit is easy to install. If you need assistance at any
point in your installation or have suggestions on how we can improve your experience, call customer support at
1-800-819-7236 or email us at sales@tamaracksolar.com
Tools Required
Tools that support the following size Hex heads:
NOTE: Anti-seize compound should be used on all stainless steel hardware in order to prevent galling when
tightening. The torque values listed below are "dry", subtract 20% if using anti-seize lubricant.
1/2" =
480\40 In\Ft Lbs (8 or 12 point socket for square head set screws)
3/8" =
240\20 In\Ft Lbs
5/16" =
144\12 In\Ft Lbs
1/4 " =
84\7 In\Ft Lb
Advertisement
Table of Contents
