Water Drainage - Miele WTD 160 Operating Instructions Manual

Installation

Water drainage

The suds are drained through a drain
pump with a 1 m delivery head. For the
water to drain freely, the hose must be
free of kinks. The elbow piece supplied
hooks onto the end of the hose. If
required, the hose can be extended to a
length of up to 5 m. Accessories are
available from Miele or from your Miele
dealer.
For a delivery head of more than 1 m
(up to a max. of 1.8 m) a replacement
drain pump will need to be fitted.
Please contact Miele for advice. With a
delivery head in excess of 1 m the hose
can be extended to a maximum of
2.5 m. Accessories are available from
Miele or from your Miele dealer.
Drainage options:
1. Directed into a sink or basin:
Please note:
– Hook the hose over the edge and
secure it.
– If the water is pumped into a
washbasin, make sure that it can
drain away freely. Otherwise there
is a risk of water overflowing or of
some of the drained water being
sucked back into the machine.
2. Connected securely to a plastic drain
pipe with a rubber nipple (there is no
need to use a siphon).
3. Connected securely to a floor drain
(gully).
4. Connected securely to a washbasin
with a plastic nipple.
78
Connected securely to a washbasin
a Adapter
b Spigot nut
c Hose clip
d End of the hose
 Fit adapter  to the sink drain outlet
using nut .
 Attach the end of hose  to adapter
.
 Use a screwdriver to tighten hose clip
 up close to the nut.