Helios CUBE User Manual page 24

HELIOS CUBE BS4850-SH
User Manual
Step 2
Insert the battery modules into the cabinet from top to bottom (see Figure3-2). Before doing it, make
sure that all battery modules are switched off and the DC breaker is in OFF state. As the battery module
weighs more than 30 kg, it is recommended to carry out the insertion by two people. In case of less than
five battery modules, the unused slots should be covered by screw-fastening the cover sheets provided
with the product.
Step 3
When inserting the battery module, pay attention to the guide bar on the side of the module, which has
to be fit into the guide groove inside the cabinet. Make sure the power and communication terminal at
the back of the module is completely fit into the socket inside the cabinet (as shown in Figure 3-3).
Helios New Energy Technology (Australia) Pty Ltd
Figure 3-2 Insert the battery modules into the cabinet
Guide bar
Guide groove
Figure 3-3 Insert the battery modules into the cabinet
mm terminal
Power/Co
3. Installation
17