Freescale Semiconductor Freedom FRDM-KE04Z Quick Start Manual page 5

Installing Drivers and Running the Out of Box Demo
Optional: Download and Install the P&E OpenSDA
0
USB Drivers found at www.pemicro.com/opensda. USB Drivers found at
Plug in a USB cable (not included) from a USB host
1
to the OpenSDA mini-B USB connector. The FRDM-
KE04Z will be powered by this USB connection.
FRDM-KE04Z comes with the mass-storage device
(MSD) Flash Programmer OpenSDA Application
preinstalled. It will appear as a removable storage drive
with a volume label of FRDM-KE04Z.
The MSD Flash Programmer also includes a USB virtual The MSD Flash Programmer also includes a USB virtual
serial port which requires an .INF file for proper
installation in Windows. The necessary .INF file is
available in the P&E OpenSDA USB Drivers (Step 0) and
also on the FRDM-KE04Z removable drive.
If the USB CDC Serial Port fails to automatically install in
Windows, follow the instructions in Step 2. Otherwise,
skip to Step 3.
TM
www pemicro com/opensda
a. Open Device Manager
2
b. Locate and right click on OpenSDA CDC b Locate and right-click on "OpenSDA – CDC
Serial Port"
c. Select "Update Driver Software"
d. "Browse" and select the FRDM-KE04Z drive
e. Click "Next" to complete the installation
The pre-installed demo running on the KE04Z
3
MCU will cycle through several colors on the RGB
LED. After this completes, tilt the board. The
color mix of the RGB LED will change based on
the accelerometer data.
Touch the capacitive slider. The green light should
4
be blinking.
5
Quick Start Guide for FRDM-KE04Z