Advertisement
For VIVOTEK Camera IP7151 and IZ7151:
1
: Open the housing cover.
2
: Release two screws both sides of camera bracket first and adjust the position of camera bracket by sliding it up and down. Use
the small wrench to do this. When completed, tighten the screws.
■ Detach the rectangular support from the camera bracket as it is not required for IP7151 and IZ7151 installation. Use the supplied L-type hex key wrench to do
this.
3
: Attach the camera to the camera bracket with an insulation pad in between; then secure the camera with the locking screw. Use
the supplied L-type hex key wrench to do this. Always check that the camera is firmly attached to the housing.
4
: Connect the power cable and Ethernet cable to the camera.
5
: To turn on the light sensor of the camera housing, connect the circuits to the general I/O terminal block of the camera.
1
2
3
4
AE2000 Camera Housing
5
Installation Guide -
3
Advertisement
