Vivotek AE2000 User Manual page 2

For VIVOTEK Camera IP7131 and IP7138:
1
: Open the housing cover.
2
: Release two screws both sides of camera bracket first and adjust the position of camera bracket by sliding it up and down. Use
the small wrench to do this. When completed, tighten the screws.
■ Detach the rectangular support from the camera bracket. Use the supplied L-type hex key wrench to do this.
3
: Attach the camera to the rectangular support with an insulation pad in between; then secure the camera with the supplied
locking screw. Use the supplied L-type hex key wrench to do this.
4
: Insert the rectangular support in the camera bracket and secure the rectangular support with the supplied locking screw. Always
check that the camera is firmly attached to the housing.
5
: Connect the power cable and Ethernet cable to the camera.
1
Installation Guide -
2
2 3
AE2000 Camera Housing AE2000 Camera Housing
4 5