Table of Contents
Advertisement
Unvented Cast Iron Gas Stoves
The heater gas inlet connection is 3/8" NPT at the valve.
The inlet is located on left side of stove. Remove front
control plate to better access the inlet.
When tightening up the joint to the valve, hold the valve
securely with a wrench to prevent movement.
Test all gas joints from the gas meter to the heater valve
for leaks using a gas analyzer or soap and water solution
after completing connection. DO NOT USE AN OPEN
FLAME.
Check the gas pressure with the appliance burning and
the control set to HIGH.
MILLIVOLT CONTROL
Figure 10
The valve regulator controls the burner pressure which
should be checked at the pressure test point.
If outlet pressure is low, check inlet pressure against data
plates or manual.
Turn captured slotted screw counter clockwise 2 or 3
turns and then place tubing to pressure gauge over test
point (Use test point "OUT" closest to control knob). After
taking pressure reading, be sure and turn captured screw
clockwise firmly to re-seal. Do not over torque. Check for
gas leaks.
NOTE: Remove control panel to access gas valve.
Test Port "OUT"
Figure 10 -
Pressure Test Point Location Millivolt Control
FP2781
Connecting directly to an unregulated
millivolt valve
p r o p a n e / L . P. G . t a n k c a n c a u s e a n
explosion.
12
CHECk GAS PRESSURE and CONNECT REMOTE RECEIVER
CONNECT REMOTE RECEIVER
1. Remove cover on control panel to show opening
2. Follow remote receiver Instructions to make all
3. Place remote receiver in the opening of control
NOTE: Do not place remote in combustion chamber.
Figure 11 -
Install Remote Receiver
FP2781
for remote receiver. Figure 11
necessary wiring connections.
panel. Use two screws provided to attach remote
receiver to the control panel. Figure 11
Remote
Receiver
Cover
ST1175
ST1175
remote receiver
58D6002
Advertisement
Table of Contents
