Table of Contents
Advertisement
LOG PLACEMENT
The positioning of the logs is critical to
the safe and clean operation of this heater.
Sooting and other problems may result if the
logs are not properly and firmly positioned
in the appliance. Never add additional logs
or embellishments such as pine cones,
vermiculite or rock wool to the heater. Only
use the logs supplied with the unit.
Failure to position the parts in accordance
with diagrams below or to use only
parts specifically approved for this
heater may result in property damage or
personal injury.
Before you begin — This unit is supplied with four
ceramic fiber logs. Do not handle these logs with your bare
hands. Always wear gloves to prevent skin irritation
from ceramic fibers. After handling the logs, wash your
hands gently with soap and water to remove any traces
of fibers.
CSVF30 / VFCS30 LOG PLACEMENT
Figure 15
1. Install back log (#1) on rear log support bracket.
2. Install left bottom log (#2) on left log support bracket in
front of back log.
3. Install right bottom log (#3) on right log support bracket
in front of back log.
4. Install top left log (#4) on top of left bottom log.
5. Install top right log (#5) on top of right bottom log.
58D6002
During initial operation of the new heater,
burning logs will give off a paper burning
smell and orange flames will be present.
Simply open the windows for a few hours
to vent the odor.
Right Top
Log #5
Top Left
Log #4
Left Bottom
Log #2
Left Log
Support
Bracket
LG937
R E
M O
T E
C O
N T
R O
L
P IL
O T
Figure 15 -
Place Logs on Grate - CSVF30/VFSC30
LG937
CSVF30 log place
Unvented Cast Iron Gas Stoves
Right
Bottom
Log #3
Back Log #1
Rear Log
Support
Bracket
Right Log
O F
F
Support Bracket
15
Advertisement
Table of Contents
