Option 01T Installation; Module Installation; Module Configuration; Figure 2-1, 1260-82 Block Diagram - Racal Instruments 1260-82 User Manual

Option 01T
Installation
Module
Installation
Module
Configuration
Installation Instructions 2-2
Installation of the Option 01T is described in the Installation and
Setup section of the 1260A-Option 01T Users Manual, Publication
No. 980806-999
!
Only install a 1260A Option 01T controller with
release 7.1 or later firmware. The 1260-82 is not
compatible with the older 1260 Option 01 controller.
Installation of the 1260-82 Switching Module into a VXI
mainframe, including the setting of switches SW1-1 through SW1-
4, SW2, and SW3, is described in the Installation and Setup
Section of the 1260A Option 01T Users Manual, Publication No.
980806-999.
The 1260-82 is a VXI 1X2 optical switch module consisting of up
to six optical switches. Refer to Figure 2-1 for a block diagram of
the basic 1x2 switch used in a 1260-82. There are up to six 1x2
available in the 1260-82.
The 1260-82 module can be organized via software as N
independent 1X2 optical switches or as N synchronous 1X2
switches (where N = 3,4, or 6) by use of the INCLUDE command
(Refer to the 1260-01T User Manual).
COM n

Figure 2-1, 1260-82 Block Diagram

.
NOTE:
(n= 0 to 5)
1260-82 User Manual
CH n0
CH n1