Table of Contents
Advertisement
Declaration of Conformity
Notice to OEM integrator
1. In the users manual of the end of product, the end user has to be informed to keep
at least 20cm separation with the antenna while this end product is installed and
operated.
2. The antenna(s) used for this transmitter must not be collocated or operating in con-
junction with any other antenna or transmitter within a host device, except in accor-
dance with FCC multi-transmitter product procedures.
3. Only those antennas with same type and lesser gain filed under this FCC ID num-
ber can be used with this device.
4. The regulatory label on the final system must include the statement: "Contains
FCC ID: M82-WISE2410" or using electronic labeling method as documented in KDB
784748.
5. The final system integrator must ensure there is no instruction provided in the user
manual or customer documentation indicating how to install or remove the transmitter
module except such device has implemented two-ways authentication between mod-
ule and the host system.
6. The final host manual shall include the following regulatory statement: This equip-
ment has been tested and found to comply with the limits for a Class B digital device,
pursuant to Part 15 of FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation. This equipment
generates, uses, and can radiate radio frequency energy. If not installed and used in
accordance with the instructions, it may cause harmful interference to radio commu-
nications. However, there is no guarantee that interference will not occur in a particu-
lar installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by tuning the equipment off and on,
the user is encouraged to try and correct the interference by one or more of the fol-
lowing measures:
◼
Reorient or relocate the receiving antenna.
◼
Increase the distance between the equipment and the receiver.
◼
Connect the equipment to outlet on a circuit different from that to which the
receiver is connected.
◼
Consult the dealer or an experienced radio/TV technician for help.
This device complies with Part 15 of the FCC Rules. Operation is subject to the fol-
lowing two conditions: (1) This device may not cause harmful interference, and (2)
this device must accept any interference received, including interference that may
cause undesired operation.
FCC Caution: Any changes or modifications not expressly approved by the party
responsible for compliance could void the user's authority to operate this equipment.
This transmitter must not be co-located or operating in conjunction with any other
antenna or transmitter.
Radiation Exposure Statement:
This equipment complies with FCC radiation exposure limits set forth for an uncon-
trolled environment. This equipment should be installed and operated with minimum
distance 20cm between the radiator & your body.
iii
Advertisement
Table of Contents
