Table of Contents
Advertisement
Cleaning the internal cappuccinatore under the tap
Descaling procedure
attached to the machine. Place the milk tube in the milk tube
follow the instructions on the screen.
-
-
'Deep Milk Clean': Perform the 'Deep Milk Clean' procedure with the Philips
milk circuit cleaner for a thorough cleaning of the internal milk system.
1
1 Open the door of the internal cappuccinatore.
2
2 Remove the internal cappuccinatore by pulling it down.
3
3 Disassemble the internal cappuccinatore by pulling the bottom part off the
top part.
4
4 Disassemble all
parts
5 Reassemble the internal cappuccinatore.
5
6 To place back the internal cappuccinatore, put it in upright position and make
6
sure the holes are aligned with the two tubes on the machine. Then move the
internal cappuccinatore upwards until it locks into place.
7
7 Close the door.
Visit
www.saeco.com/care
Please use Philips descaler only. Under no circumstances should you use a
descaler based on sulfuric acid, hydrochloric acid, sulfamic or acetic acid (vinegar)
as this may damage the water circuit in your machine and will not dissolve
the limescale properly. Not using the Philips descaler will void your warranty.
Failure to descale the appliance will also void your warranty. You can buy Philips
descaler from your local or online retailer or from authorized service centers.
1 When the machine asks you to descale it, tap the OK icon to start. To start
1
descaling without being prompted by the machine, tap the Clean
select 'Descale'.
2
2 Remove the drip tray, the coffee grounds container and the HygieSteam
container, empty them and put them back into place.
3 Remove the water tank and empty it. Then remove the AquaClean filter.
3
4 Pour the whole bottle of Philips descaler into the water tank and then fill it
4
with water up to the CALC CLEAN level. Then place it back into the machine.
5 Place a large container (1.5 l) under the coffee dispensing spout.
5
6 Make sure that the HygieSteam container is correctly
6
to the machine. Place the milk tube in the milk tube holder.
7 Follow the instructions on the screen to start the descaling procedure. The
7
descaling procedure lasts approx. 30 minutes and consists of a descaling cycle
and a rinsing cycle.
8 Once the descaling cycle is finished, you need to rinse the water tank and
8
water circuit. Follow the instructions on the screen.
9
9 Place a new AquaClean filter in the water tank and activate it (see
the AquaClean water filter (5
Tip: Using the AquaClean filter reduces the need for descaling!
and clean them under the tap.
for detailed video instructions.
min.)).
holder
and
icon and
assembled
and attached
Activating
Advertisement
Table of Contents
