Table of Contents
Advertisement
Removing and inserting the brew group
Removing the brew group from the machine
Reinserting the brew group
Cleaning and maintenance
When the AquaClean status indicator drops to 0% or when the machine reminds
you to replace the AquaClean filter:
1
1 take out the old AquaClean water filter.
2
2 install a new filter and activate it as described in chapter 'Activating the
AquaClean water filter (5 min.)'.
Replace the AquaClean water filter at least every 3 months, even if the
machine does not yet indicate that replacement is required.
Go to www.saeco.com/care for detailed video instructions on how to remove,
insert and clean the brew group.
1
1 Switch off the machine.
2
2 Remove the water tank and open the service door.
3
3 Press the PUSH
handle
from the machine.
When you remove the brew group from the machine, make sure to empty the
drip tray and the coffee grounds container.
Before you slide the brew group back into the machine, make sure it is in the
correct position.
1 Check if the brew group is in the correct position. The arrow on the yellow
1
cylinder on the side of the brew group has to be aligned with the black arrow
and
N.
-
-
If they are not aligned, push down the lever until it is in contact with the
base of the brew group.
2
2 Slide the brew group back into the machine along the guiding rails on the
sides
until it locks into position with a click. Do not press the PUSH button.
3 Close the service door and place back the water tank.
3
Regular cleaning and maintenance keeps your machine in top condition and
ensures good-tasting coffee for a long time with a steady coffee flow.
Consult the table below for a detailed description on when and how to clean
all detachable parts of the machine. You can find more detailed information
and video instructions on www.saeco.com/care. See figure C for an overview of
which parts can be cleaned in the dishwasher.
and pull at the grip of the brew group to remove it
Advertisement
Table of Contents
