Ricoh A028 Service Training Manual page 122

Process Control 1 July 1994
2.11.4 Process control timing
At power ON
After power is turned on and the fusing temperature reaches 175°C, the main motor turns on to
feed out any sheets in the paper path of the machine if there are any. Then, the machine enters the
OPC idling mode. V and VR compensations are done during this period as shown below. The
0
machine enters the copy stand-by condition after the ID sensor mode finishes.
For the VR measurement, the OPC surface is charged by the transfer corona and the quenching
lamp clears it. Then, the potential sensor (B sensor) senses the OPC surface. VR compensation is
done at power on and after every 500 or more copies.
For the V measurement, the OPC surface is charged by the charge corona. Then, the potential
0
sensor (B sensor) senses the OPC surface without exposing. V compensation is done only at
0
power on when the machine has been at rest more than one hour. The V measurement is also
0
done at the end of each copy run. When the machine has been at rest less than one hour, the value
of V immediately before the power was turned off is used as is.
0
2-86