Stiga CR 430 Li 80 Series Operator's Manual page 152

1. The motor does not
start when the switch
is pressed (type "I"
handle).
2. The motor does not start
when the switch is pres-
sed (type "I" handle).
3. The motor does not start
when the switch is pres-
sed (type "I" handle).
4. The motor does not start
when the switch is pres-
sed (type "I" handle).
5. The motor does not start
when the switch is pres-
sed (type "I" handle).
6. When pressing the
power button, the
display does not turn
on (type "II" handle -
Advanced Series).
7. When pressing the
power button, the
display does not turn
on (type "II" handle -
Advanced Series).
8. When pressing the power
button, the display does
not turn on and the ma-
chine emits an acoustic
buzzer (type "II" handle
- Advanced Series).
9. The motor is running but
the cutting means is sta-
tionary (type "I" handle).
10. The motor shuts down
whilst working.
11. The motor shuts down
whilst working.
12. The motor shuts down
whilst working.
13. The motor stops while
working and the machine
alarm buzzer is trigge-
red (type "I" handle).
14. The motor stops while
working and the machine
alarm buzzer is trigge-
red (type "I" handle).
Safety key is not inserted or is inserted
incorrectly.
Battery is not inserted or is
inserted incorrectly.
Low battery.
Motor start-up is slow.
The thermal protection has tripped
due to overheating of the motor.
Safety key is not inserted or is inserted
incorrectly.
Battery is not inserted or is
inserted incorrectly.
Internal motor anomaly.
The cutting means fittings are loose.
Battery is not inserted correctly.
Low battery.
Obstructions that prevent
rotation of the cutting means.
The thermal protection has tripped
due to overheating of the motor.
Thermal protection has tripped due to
excessive current absorption caused by:
• Excessively high grass cutting.
• Obstructions that prevent
rotation of the cutting means.
• Too much grass debris accumulated
in the chassis and discharge channel.
Insert the key (par. 6.3).
Open the hatch and check that the battery
is fitted in its housing correctly (par. 7.2.4).
Check the battery status and recharge
if necessary (par. 7.2.3).
Press and hold the control lever
for 1-3 seconds (par. 5.2).
Wait for at least 5 minutes and
then restart the machine.
Insert the key (par. 6.3).
Open the hatch and check that the battery
is fitted in its housing correctly (par. 7.2.4).
Remove the safety key and contact
the Technical Assistance Centre for
checks, replacements or repairs.
Immediately turn off the motor
and remove the safety key.
Contact an authorised Technical
Assistance Centre for checks,
replacements or repairs (par. 8.1).
Open the hatch and check that the battery
is fitted in its housing correctly (par. 7.2.4).
Check the battery status and recharge
if necessary (par. 7.2.3).
Remove the safety key, put on your work
gloves and remove any grass remains or
debris from the lower part of the machine
and/or the discharge channel.
Wait for at least 5 minutes and
then restart the machine.
• Set a higher cutting height when the
grass is very tall, then set a lower height
and cut the lawn again (par. 6.4.1).
• Remove the obstructions (par. 7.3.2).
• Clean the machine (par. 7.3.1)
Wait for at least 5 minutes and
then restart the machine.
EN - 14