Mitsubishi MELSEC-A AJ65VBTCU-68DAVN User Manual page 75

5 PROGRAMMING
Initial settings
Changing of initial settings
Initial setting change
Processing at initial settings
Setting of digital values
Digital value
setting
Analog output enable/disable specification
Analog output
enable
Processing at error occurrence
Error reset
Write of remote output signals
The program enclosed by the dotted line is necessary only when the initial settings are changed.
5 - 13
MELSEC-A
Analog output enable/
disable setting (RWw8)
CH.1 to CH.4 output range
setting (RWw9)
Writes to master station
HOLD/CLEAR setting
(RWwB)
Writes to master station
Turns on initial data
processing completion flag
(RY18).
Turns on initial data
setting request flag (RY19).
Analog output enable/
disable setting (RWw8)
CH.1 to CH.4 output range
setting (RWw9)
Writes to master station
Turns on initial data setting
request flag (RY19).
Turns off initial data
processing completion flag
(RY18).
Turns off initial data setting
request flag (RY19).
CH.1 digital value
setting (RWw0) : 500
CH.2 digital value
setting (RWw1) : 1000
Writes to master station
Turns on CH.1 analog
output enable/disable
flag (RY00).
Turns on CH.2 analog
output enable/disable
flag (RY01).
Read CH. check code
(RWr0, RWr1).
Reads error code (RWr8).
Turns on error reset
request flag (RY1A).
Turns off error reset
request flag (RY1A).
Y400 to Y41F are written
into RY00 to RY1F.
5 - 13