Barco iCon H250 Installation Manual page 10

2. Hard disk recovery procedure
Image 2-8
Note: You will see appear the following message: mount: block device /dev/sr0 is write-protected, mounting read-only
3. At the prompt, enter the following text: partimage
Image 2-9
4. Navigate to the item Image file to create/use using the tab key and enter the following text:/mnt/cdrom/iconh400.000
Image 2-10
Note: iconh400.000 is the name of the file with the firmware and data. It may differ depending on the version and the projector
type you are recovering!
5. Press tab
6. Use ↓ and the space bar to select the item Restore partition from an image file
7. Press F5 , verify the partition description and use the space bar to close the window
8 R59770070 ICON H250 / ICON H400 31/01/2007