Installation Instructions - Nvidia ConnectX-6 User Manual

Infiniband/vpi adapter card

Hide thumbs Also See for ConnectX-6:

Manual (88 pages)

User manual (79 pages)

User manual (68 pages)

Table Of Contents

100

101

102

103

104

105

106

107

Table of Contents



Due to risk of damaging the EMI gasket, it is not recommended to replace the bracket more

than three times.

To replace the bracket you will need the following parts:

•

The new brackets of the proper height

•

The 2 screws saved from the removal of the bracket

Removing the Existing Bracket

Using a torque driver, remove the two screws holding the bracket in place.

Separate the bracket from the ConnectX-6 card.



Be careful not to put stress on the LEDs on the adapter card.

Save the two screws.

Installing the New Bracket

Place the bracket onto the card until the screw holes line up.



Do not force the bracket onto the adapter card.

Screw on the bracket using the screws saved from the bracket removal procedure above.



Use a torque driver to apply up to 2 lbs-in torque on the screws.