Current Scanner Info; Scanner Probe; Scanner Driver Manager - Microtek ScanMaker i700 User Manual

Menu bar
various scanners, select the scanner to be used.

Current Scanner Info

This command provides information about your current scanner.
When you choose this command, a dialog box appears showing the
scanner model, Scanner ID number, Interface, Driver version, and
firmware version, etc.

Scanner Probe

This command displays the detected scanner devices.
If your scanner does not show in the list, make sure your scanner is
connected and turned on, then click on the Probe button in the
dialog box.
This command shows the scanner information on your SCSI, USB, or
FireWire chain. If your scanner does not show in the Scanner Probe
dialog box, make sure your scanner is properly installed, connected,
and turned on, and then click the Probe button. For details on
connecting your scanner, refer to your scanner hardware installation
guide.

Scanner Driver Manager

The Scanner Driver Manager keeps track of the scanners being used
on your system and the interface bus/ID numbers occupied by the
scanners. By keeping a record of this information, the Scanner
Driver Manager allows ScanWizard 5 to start up more quickly, as
there is no need to look for devices on the other interface buses.
Update List (unimplemented)
This command refreshes the SCSI buses and updates the Scanner
menu with the current scanner list.
This is most useful when ScanWizard 5 is brought up but one of the
scanners is not turned on or has not become ready. Only the current
file:///D|/sw56/Menu_bar.htm (2 of 20) [12/16/03 11:57:50 PM]