Safety Precautions - Vitek VT-1465 Manual Instruction

ENGLISH
BLENDER SET VT-1465
The blender is included into the blender set and
intended for whisking, mixing, chopping.
DESCRIPTION
1. Detachable blender attachment
2. Attachment installation place
3. Motor unit
4. «Turbo» mode button
5. ON button
6. Speed control knob
7. Measuring cup
8. Whisk attachment gear
9. Whisk attachment
10. Chopper geared lid
11. Chopper bowl
12. Chopping knife
13. Measuring cup lid
ATTENTION!
For additional protection it is reasonable to install a
residual current device (RCD) with nominal opera-
tion current not exceeding 30 mA. To install an RCD
contact a specialist.

SAFETY PRECAUTIONS

Before using the blender set, read this instruction
carefully. Keep these instructions for further refer-
ence. Use the blender set for its intended purpose
only as specified in this manual.
Mishandling of the unit can lead to its breakdown,
injury to the user, as well as cause harm to the user
or damage to his/her property.
•
Before connecting the unit to the mains, make
sure that the voltage specified on the unit corre-
sponds to your home mains voltage.
•
Do not use the unit outdoors.
•
Do not use the unit near hot surfaces (such as gas
or electric stove, oven).
•
Provide that the power cord does not touch sharp
edges of furniture and hot surfaces.
•
Do not touch the motor unit body, the power cord
and the plug with wet hands.
•
To avoid risk of electric shock or fire, do not
immerse the unit, the power cord and the power
plug into water or any other liquids.
•
If the unit is dropped into water:
– do not touch the water;
– unplug the unit immediately, only after that
you may take the unit out of water;
– apply to an authorized service center for test-
ing or repairing the unit.
•
Before using the unit for the first time, thoroughly
wash all the removable attachments and contain-
ers that will contact food.
•
Use only the attachments supplied with the unit.
•
Before using the unit, make sure that the attach-
ments are set and fixed properly.
•
It is not allowed to switch the unit on without
attachments and foodstuffs for processing.
•
Always unplug the blender if it is left unattended
and before assembling, disassembling or clean-
ing; as well as after using.
•
Place the chopper bowl on a flat stable surface.
•
Foodstuffs should be put into the chopper bowl
before the unit is switched on.
•
Cool down hot foodstuffs before putting them into
the measuring cup or the chopper bowl.
•
Do not overfill the chopper bowl with food and
watch the level of poured liquids.
•
The unit is not intended for mixing of sticky and
viscous ingredients.
•
If rotation of the chopping knife is hindered dur-
ing the operation of the chopper, unplug the
unit and carefully remove foodstuffs that prevent
blade rotation.
•
Remove products and pour out liquids from the
chopper bowl only after the chopper knife is com-
pletely stopped and removed.
•
The cutting edges of the chopping knife and of
the blender attachment are very sharp and dan-
gerous. Handle these attachments very carefully!
•
Do not touch the rotating parts of the unit. Do not
let hair or free hanging clothes get into the rota-
tion area of the blender attachment knife or whisk.
•
Handle sharp cutting blades with care, when
emptying the bowl and during cleaning.
•
To unplug the unit, do not pull the power cord,
instead take the power cord plug and disconnect
it from the mains.
•
Do not place the chopper bowl and the measuring
cup into a microwave oven.
•
Do not put the attachments and the bowls in a
dishwashing machine.
•
For children safety reasons do not leave poly-
ethylene bags used as a packaging unattended.
Attention! Do not allow children to play with poly-
ethylene bags or packaging film. Danger of suf-
focation!
•
Never use the unit if the power cord or the power
plug is damaged, if the unit works improperly or
after it was dropped.
•
Close supervision is necessary when children
or people with disabilities are near the operat-
ing unit.
•
Do not allow children to use the blender unsu-
pervised.
•
Do not leave children unattended to avoid them
using the unit as a toy.
•
Do not allow children to touch the body of the
motor unit, the power cord or the power plug dur-
ing operation of the unit.
•
During the unit operation and breaks between
operation cycles, place the unit out of reach of
children.
•
The unit is not intended to be used by people with
physical, sensory or mental disabilities (includ-
8