Using The Chopper - Vitek VT-1465 Manual Instruction

ENGLISH
•
Insert the power plug into the mains socket.
•
Make sure that speed control knob (6) is set to
«LOW» position.
•
Immerse the whisk (9) into the bowl with food.
Note: You can put the foodstuffs into the cup (7).
•
To switch the unit on, press and hold down the but-
ton (5).
•
You can adjust speed with speed control knob (6).
•
After you finish using the unit, take the power plug
out of the mains socket, disconnect the whisk gear
(8) from the motor unit (3) by turning the gear (8)
clockwise.
•
Remove the whisk (9) from the gear (8).
ATTENTION!
– Do not use the whisk attachment (9) to knead tight
dough.
– Put products into the bowl before switching the
unit on.

USING THE CHOPPER

The chopper is used to chop meat, cheese, onion,
herbs, garlic, carrots, walnuts, almonds, prunes, veg-
etables and fruit.
ATTENTION!
Do not chop very hard products, such as ice cubes,
frozen products, nutmegs, coffee beans, cereals etc.
Before you start chopping:
– Cut meat, cheese, onions, vegetables or fruit into
pieces approximately 2x2 cm in size.
– Remove stems of herbs, shell nuts.
– Remove bones, sinews and cartilage from meat.
Chopping
Caution: the blades of the chopping knife (12) are
very sharp!
Always hold the chopping knife (12) by the upper plas-
tic end.
•
Place the chopper bowl (11) on a flat stable surface.
•
Set the chopping knife (12) on the axis inside the
chopper bowl (11).
•
Put the products into the chopper bowl (11).
Note: Do not switch the unit on when the chopper bowl
(11) is empty.
•
Place the geared lid (10) on the chopper bowl (11)
and rotate it clockwise until bumping.
•
Install the motor unit (3) on the geared lid (10) feed-
ing chute, turn the motor unit (3) clockwise until
bumping, make sure that the motor unit (3) is fixed
properly.
•
Install the motor unit (3) strictly in the vertical posi-
tion and evenly.
– Connect the unit to the mains by inserting the
power cord plug into the mains socket.
– Make sure that speed control knob (6) is set to
«LOW» position.
– To switch the unit on, press and hold the button (5).
– You can adjust speed with speed control knob (6).
– During operation hold the motor unit (3) with one
hand and the chopper bowl (11) with the other hand.
– After using the unit, wait until the chopping knife
(12) fully stops.
– Remove the power plug from the mains socket.
– Disconnect the motor unit (3) from the geared lid
(10) chute by turning the motor unit (3) counter-
clockwise.
– Remove the geared lid (10) having turned it coun-
terclockwise.
– Carefully remove the chopping knife (12) taking it
by the plastic end.
– Take the chopped products out of the chopper
bowl (11).
ATTENTION!
Strictly follow the described sequence of operations.
Notes: To engage «Turbo» mode press and hold button
(4) for 30 seconds when using blender attachment (1),
60 seconds when using whisk attachment (9), 30 sec-
onds when chopping in the chopper bowl (11).
To achieve the best results, refer to the table
below:
When using the blender attachment:
Foodstuff Maximum amount
of foodstuff
Fruit/vegeta-
50-100 gr.
bles
Baby food/
50-200 ml.
soups/sauces
Mixed drinks/
50-500 ml.
cocktails
When grinding in the chopper:
Foodstuff Maximum
amount of
foodstuff
Boiled eggs
Bread crumbs
Dark chocolate
Garlic
Onion
Meat/fish
Herbs
Cheese
Nuts
Note: all data in this table are given as recommen-
dations.
CLEANING
Attention! The blades of the chopping knife (12) are
very sharp and may be dangerous.
Handle the chopping knife (12) very carefully!
•
Unplug the unit before cleaning.
10
Approximate
processing
time, seconds
25
25
25
Approximate
processing
time, seconds
2 pc. 4 х 1 sec
40 g. 5
100 g. 5
50 g. 5 х 1 sec
200 g. 5 х 1 sec
200 g. 5
30 g. 5
200 g. 5
100 g. 5