Advertisement
Table of contents
Base Assembly - Section 1 – Page 4
Belt / Brushroll - Section 2 – Page 4
Motor / PCB - Section 3 – Page 4 / 5
Motor Assembly / Intake Pivot Assembly / Fan Housing - Section 4 – Page 5 / 6
Handle Detent - Section 5 – Page 6
LED PCB - Section 6 – Page 6
Power PCB - Section 7 – Page 6 / 7
Cord Assembly / Power Cord - Section 8 – Page 7
Bag Assembly - Section 9 – Page 8
Carry Handle - Section 10 – Page 8
Wiring Diagram - Section 11 – Page 9
Electrical Troubleshooting - Section 12 – Page 10 / 11
2 |
P a g e
Advertisement
Need help?
Do you have a question about the ELEVATE Control UK30100PC and is the answer not in the manual?
Questions and answers
The vacuum is not picking up lint from the floor.
The Oreck ELEVATE Control UK30100 vacuum may not be picking up lint due to several possible reasons:
1. Clogged Filtration Bag – The vacuum should not be used without the inner filtration bag in place. A full or improperly installed bag can reduce suction.
2. Blocked Airflow – Obstructions in the hose or nozzle can limit suction power.
3. Brush Roller Belt Issue – The vacuum uses an Endurolife Belt designed for long life, but if the brush roller is not rotating properly due to debris or wear, it may not effectively lift lint.
4. Motor Overload Protection Activated – If the vacuum has shut down due to an obstruction or thick carpet, it needs to be reset.
5. Improper Power Settings – Ensure that the vacuum is switched on and functioning properly.
Checking and addressing these issues can help restore proper performance.
This answer is automatically generated