Audio System CARBON Series Owner's Manual

High-performance car-amplifier

Advertisement

Quick Links

s i n c e 1 9 8 8
R
g e r m a n s o u n d
High-Performance
Car- amplifier
owner's manual
Carbon-500.1D
Carbon-250. 4
designed and engineered by audio system
Germany

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the CARBON Series and is the answer not in the manual?

Questions and answers

Summary of Contents for Audio System CARBON Series

  • Page 1 1 9 8 8 g e r m a n s o u n d High-Performance Car- amplifier owner‘s manual Carbon-500.1D Carbon-250. 4 designed and engineered by audio system Germany...
  • Page 2 - Variable switchable Low Pass Filter from 50 to 4000 Hz or variable High Pass Filter from 50 to 4000 Hz - compatible to Audio System RTC - 2-channel pre-out - Input Sensitivity: variable 200 mV maximum to 6 V minimum...
  • Page 3: Power Connection

    CArbon series power connection by audio system carbon-500.1D / carbon-250. 4 1. Battery disconnection First disconnect the power supply of the vehicle. This works out the best by removing the ground cable of the battery. 2. Ground connection Connect the GND (ground) connection of the amplifier with the car chassis.
  • Page 4: Rca Connection

    The wired remote controller RTC can be installed to adjust the output level. With CARBON-250. 4 the RTC adjusts the level of channel 3 and 4 only when lowpass filter is selected. In this regard, AUDIO SYSTEM germany recommends to adjust your amplifier through a specialized service center, dealer or a specialist.
  • Page 5: Speaker Connection

    CArbon series speaker connection by audio system Carbon-500.1d Mono Betrieb speaker impedance 2 ~ 8 Ohm Dual Mono Betrieb speaker impedance 4 ~ 8 Ohm Please take care the CARBON-500.1 d is a pure 1 channel amplifier. If using 2 subwoofers or a double...
  • Page 6 CArbon series speaker connection by audio system Carbon-250. 4 2-Channel Mono speaker impedance 4 ~ 8 Ohm CARBON-250. 4 4-Channel Stereo speaker impedance 2 ~ 8 Ohm CARBON-250. 4 3-Channel Stereo + Mono speaker impedance 4 ~ 8 Ohm CARBON-250. 4...
  • Page 7: Troubleshooting

    CArbon series Trouble Shooting by audio system This power amplifier is featured with an efficient protection system to prevent any damages like over-heating, overvoltage, short-circuit and DC at the loudspeaker output. Occuring an error the protection-LED will light in red. In order to check the problem, first turn down all levels of the head unit, afterwards turn it off.
  • Page 8: Specifications

    176(W) x 51(H) x 280(L) mm si n c e 1 9 8 8 g e r m a n s o u n d Audio System Germany F all torstraße 6 - 76707 Hambrücken designed and engineered by audio system Germany...

This manual is also suitable for:

Carbon-500.1dCarbon-250.4

Table of Contents