RSV4 ABS
Bearing fitting
BALANCING COUNTERSHAFT BEARING INSTALLATION
FLYWHEEL-SIDE
•
Heat up the crankcase to 150°C (302°F).
•
Prepare the following tools:
Specific tooling
020364Y 25 mm Adaptor
020359Y 42 x 47 mm punch
020376Y Adapter handle
•
Position the new bearing with its
groove on the outside diameter facing
outward with respect to the crankcase.
In this way it will be possible to install
the bearing retainer in the groove.
•
Using the suitable tools, fit the bearing
in the crankcase until tool stops
Engine
ENG - 371