Download Print this page

APRILIA RSV4 ABS 2009 Manual page 161

Advertisement

RSV4 ABS
circuit not operational
Error cause
Replace injection ECU
Stop lights relay error P0610
short circuit to positive/ short circuit to negative / open circuit
Error cause
If shorted to positive: excessive voltage has been detected at PIN 31. If shorted to negative:
no voltage has been detected. If the circuit is open: an interruption has been detected
Troubleshooting
If shorted to positive: check the relay electrical specifications are correct by disconnecting
it from the cable harness. If they are not correct, replace the relay; if OK, restore the cable
harness (Blue/Pink cable)
If shorted to negative: check the relay electrical specifications are correct by disconnecting
it from the cable harness. If they are not correct, replace the relay; if OK, restore the cable
harness (Blue/Pink cable)
If the circuit is open: check the relay electrical characteristics are correct by disconnecting
it from the cable harness; if not OK, replace the relay, if OK, check relay connector, engine-
vehicle cable harness connector and ENGINE connector of the Marelli control unit: if not
OK, restore; if OK, check continuity of cable harness (Blue/Pink cable)
DIAGNOSIS INSTRUMENT: LOGIC ERRORS
Level 2 safety reset P0608
Error cause
As the level 2 safety system (comparison between requested torque and calculated torque)
has detected a fault, the control unit has reset engine (C gravity). The instrument panel does
not indicate the presence of this error even in the ATT status.
Troubleshooting
Continue fault search for the other errors detected
Safety Engine Stop P0609
Error cause
Since the safety system has detected a serious fault, the control unit has shut off the engine
Troubleshooting
Continue fault search for the other errors detected.
Saved data file (for safety) P0611
Filled
Error cause
Electrical system
ELE SYS - 161

Advertisement

loading

This manual is also suitable for:

Rsv4 abs 2010Rsv4 abs 2011