Table of Contents
Advertisement
After storing carrier code(s) and area code(s), you must relate the stored area code(s) to your
chosen lower costing carrier code. It is only necessary to relate area codes to carrier codes if
more than one carrier code has been stored. If only one carrier code has been stored, any area
codes you store (up to 25) will automatically be dialled with that carrier code.
- To exit the operation, press
- *1: The factory preset is 0000.
- *2 If you need more relating area codes to carrier codes, repeat the
steps from 5.
6.12.4. Automatic Route Selection On/Off
- To exit the operation, press
- *1: The factory preset is 0000.
6.13. Summary of Programmable Functions
You can select and execute the following functions by pressing direct command as follows
without programming.
These operations need to be done with the Handset near the base unit.
Press
. Press
any time.
any time.
or
until the arrow points to
17
Advertisement
Table of Contents
