Table of Contents
Advertisement
Checking of Battery
1. Open the right side cover.
2. Clear the dust and corrosion off the surface of the battery.
3. Place the vehicle in a vertical position and check the solution
level to see if it is between the upper and lower limit marks.
If not, replenish the battery with distilled water.
4. Replace the wire leads if their ends are corroded.
Caution
1. To remove the battery, disconnect the negative (-) terminal before the positive (+) terminal and to install it, connect the
positive (+) terminal before the negative (-) terminal. Contact of the positive (+) terminal with the vehicle body should
be avoided.
2. 0nce the battery is used, do not add diluted sulfuric acid into it again. Add distilled water but make sure it is not above
limit mark, otherwise it can be overflowed to corrode the motorcycle.
3. The battery contains sulfuric acid which will cause serious physical damage if it gets onto the skin or into the eyes. In
the case of contamination, wash the contaminated part with water for five minutes and then call or go to the doctor
immediately.
4. Be sure that any foreign matters are kept from getting into the battery when removing or installing it.
5. Make sure the battery vent tube is always unclogged.
Replacement of Fuse
1. Set the ignition switch to the "OFF" position. Be sure to use a fuse of the specified capacity (1OA) for replacement.
2. Open the left side cover, remove the fuse retainer beside the battery and put in a new one.
3. If the new fuse gets blown immediately after it is installed, it means there is a fault in the electric system.
Warning
Avoid washing the battery with water when washing the motorcycle. Do not use the fuse exceeding specified specs,
otherwise the circuit system will be affected badly and even the engine may be shut off or the motorcycle may be burnt out
and the power of the engine may be lost.
31
Positive terminal
Negative terminal
Moto3 User Manual
Advertisement
Table of Contents
